Kia Forte: Accelerator Pedal Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), the nuts (C) and then remove
the accelerator pedal module.
|
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
Accelerator Pedal Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...
See also:
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loosen 2 screws holding the overhead console (A).
3.
...
Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
Engine And Transaxle Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
•
Adjust shift cable.
•
Adjust throttle cable.
•
...
Copyright © www.kifomanual.com 2014-2025