Kia Forte: Accelerator Position Sensor (APS) Description

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Heated Oxygen Sensor (HO2S) Installation

   • Install the component with the specified torques. • ...

Accelerator Position Sensor (APS) Specification

Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 W.O.T 3.85 ~ 4.35 1.93 ~ 2.18 ...

See also:

Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") Remove the manual transaxle. (Refer to Manual ...

Shift Lever Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Select cable assembly 5. Retainer ...

If you have a flat tire (If equipped)
Jack and tools The spare tire, jack, jack handle and wheel lug nut wrench are stored in the luggage compartment. Remove the luggage under tray out of the way to reach the equipment. (1) Jack h ...