Kia Forte: CVVT Oil Control Valve (OCV) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the CVVT oil control valve connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
CVVT Oil Control Valve (OCV) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
CVVT Oil Control Valve (OCV) Installation
•
Install the component with the specified torques.
•
...
See also:
Ambient Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of the ambie ...
Troubleshooting
Vehicle inspection
SYMPTOM CHART
Symptom
Suspect Area
Remedy (See page)
Squeak or grunt-noise from the front suspension,
occurs more in cold ambient t ...
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Copyright © www.kifomanual.com 2014-2025