Kia Forte: DC/DC Converter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / DC/DC Converter Removal
| 1. |
Disconnect the battery negative (-) cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
|
| 3. |
Disconnect the DC/DC converter connector (A).
|
| 4. |
Remove the DC/DC converter (A).
|
DC/DC Converter Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting ...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
See also:
26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram
...
Rear Torsion Beam Axle Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...
Copyright www.kifomanual.com 2014-2025