1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
3. |
Disconnect the injector connector (A).
|
4. |
Disconnect the fuel feed tube quick-connector (B).
|
5. |
Remove the installation bolt (C), and then remove the delivery
pipe & injector assembly from the engine.
|
Engine Mounting Removal and Installation
Engine mounting bracket
1.
Install the jack to the edge of oil pan to support the engine.
...
Tightening Torques
Item
N.m
kgf.m
lb-ft
Ignition coil installation bolt
9.8 ~ 11.8
1.0 ~ 1.2
7.2 ~ 8.7
Spark plug installation
14.7 ~ 24. ...
TJ Joint Components
[LH]
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9. Snap ring
10. TJ c ...