Kia Forte: Engine Coolant Temperature Sensor (ECTS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ECTS connector.
|
| 3. |
Remove the ECTS.
|
| 4. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 1 and 3.
|
| 5. |
Check that the resistance is within the specification.
|
Engine Coolant Temperature Sensor (ECTS) Circuit Diagram
(M/T)
(A/T)
...
Engine Coolant Temperature Sensor (ECTS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Purge Control Solenoid Valve (PCSV) Description
Purge Control Solenoid Valve (PCSV) is installed on the intake manifold
and controls the evaporative purge between the canister and the intake manifold.
It is a normally closed solenoid valve ...
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...
Transaxle Control Module (TCM) Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis
ground using the backside of TCM harne ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026