Kia Optima Manuals

Kia Forte: ETC (Electronic Throttle Control) System Installation - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: ETC (Electronic Throttle Control) System Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
ETC (Electronic Throttle Control) System Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to ...

Manifold Absolute Pressure Sensor (MAPS) Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...

See also:

Alternator Components
1. OAD (Overrunning Alternator Decoupler) pulley 2. Front housing 3. Front bearing 4. Stator 5. Rotor 6. Rear bearing 7. Rear housing 8. Rectifier assembly 9. Re ...

CVVT & Camshaft Removal
   • Use fender covers to avoid damaging painted surfaces. ...

Operation
Evaporative System Monitoring Evaporative And ORVR Emission Control System This system consists of a fill vent valve, fuel shut-off valve, fuel cut valve (for roll over), two way val ...

Categories

Copyright � www.kifomanual.com 2014-2026