Kia Forte: Filler-Neck Assembly Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Removal
| 1. |
Open the fuel filler door and unfasten the filler-neck assembly
mounting screw (A).
|
| 2. |
Remove the rear-LH wheel, tire, and the inner wheel house.
|
| 3. |
Disconnect the fuel filter hose (A) and the ventilation hose (B).
|
| 4. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting bolts (C).
|
Fuel Line Installation
•
Install the component with the specified torques.
•
...
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
See also:
Installation
1.
Install in the reverse order of removal.
2.
Adjust the ignition lock switch.
(1)
In state of full stro ...
Specifications
AVN Head Unit
Item
Specification
Power supply
DC 14.4V negative ground
Load Impedance
4ohm × 4
Tuning type
PLL SYNTH ...
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
Copyright © www.kifomanual.com 2014-2025