Kia Forte: ESC Control Module Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module Installation
| 1. |
Install in the reverse order of removal.
|
| 2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
| 3. |
After installation, bleed the brake system.
(Refer to ESC bleeding of ESC system)
|
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A) , then disconnect the
connector.
...
Front Wheel Speed Sensor Components
1. Front wheel speed sensor
2. Front wheel speed sensor connector
...
See also:
Power Door Lock Switch Inspection
Driver Door Lock Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Roof antenna Installation
1.
Install the roof antenna.
2.
Connect the roof antenna connectors.
3.
Install the rear roof trim.
...
Copyright © www.kifomanual.com 2014-2025