Kia Forte: Interior
| Interior A |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior B |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior C |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior D |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø8.5) |
Cowl crossbar mounting hole (Ø9) |
|
|
|
|
| Front door checker mounting hole (Ø13) |
Cowl side trim mounting hole (Ø8.5) |
Curtain airbag mounting hole (Ø9) |
|
|
|
|
| Seat belt height adjuster upper mounting hole (Ø6.6) |
Seat belt height adjuster lower mounting hole (Ø13) |
Front door striker mounting hole (Ø13) |
|
|
|
|
| Seat belt pretensioner mounting hole
(Ø12.5) |
Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø10) |
|
|
|
|
| Rear pillar trim mounting hole (Ø10) |
Rear pillar trim mounting hole (Ø6.6) |
Rear pillar trim mounting hole (7X12) |
|
|
|
|
| Wheel house panel trim mounting hole (Ø8.5) |
Rear package tray panel tooling hole
(Ø6) |
Parking brake lever mounting hole (Ø9) |
|
|
|
|
| Floor wiring harness mounting hole (7X12) |
Front seat mounting hole (Ø13) |
Floor wiring harness mounting hole (7X12) |
|
|
|
|
| Floor wiring harness mounting hole (7X12) |
Rear floor panel tooling hole (7X12) |
Rear seat mounting hole (Ø16.2) |
|
|
|
|
| Rear floor panel tooling hole (8.5X8.5) |
Rear transverse trim mounting hole (Ø8.5) |
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective ECM or when
providing additional keys to the vehicle owner.
The procedure st ...
Blower Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
...
Daytime running light
Daytime Running Lights (DRL) can make it easier for others to see the front of
your vehicle during the day.
DRL can be helpful in many different driving conditions, and it is especially
helpful aft ...
Copyright © www.kifomanual.com 2014-2025