Kia Forte: Interior
| Interior A |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior B |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior C |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
| Interior D |
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
Cowl crossbar mounting hole (Ø9) |
|
|
|
|
| Front door checker mounting hole (Ø13) |
Cowl side trim mounting hole (Ø8.5) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Seat belt height adjuster upper mounting hole (Ø16) |
Seat belt height adjuster lower mounting hole (Ø16) |
Rear door checker mounting hole (Ø13) |
|
|
|
|
| Seat belt retractor mounting hole (Ø12.5) |
Curtain airbag mounting hole (Ø6.6) |
Curtain airbag mounting hole (Ø6.6) |
|
|
|
|
| Curtain airbag mounting hole (Ø8) |
Curtain airbag mounting hole (Ø6.6) |
Wheel house mounting hole (Ø8.5) |
|
|
|
|
| Rear door striker mounting hole (Ø13) |
Wheel house mounting hole (Ø8) |
Parking brake lever mounting hole (Ø9) |
|
|
|
|
| Floor wiring harness mounting hole (12X7) |
Front seat mounting hole (Ø13) |
Floor wiring harness mounting hole (12X7) |
|
|
|
|
| Floor wiring harness mounting hole (12X7) |
Rear floor panel tooling hole (12X7) |
Rear seat mounting hole (Ø16) |
|
|
|
|
| Rear floor panel tooling hole (Ø6.6) |
Rear transverse trim mounting hole (Ø8.5) |
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
See also:
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
Engine Oil Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
Dynamic Damper Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
Copyright © www.kifomanual.com 2014-2025