Kia Forte: Front Door Window Glass Replacement - Front Door - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Door Window Glass Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Replacement

1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).
(4Door, 5Door)

(2Door)

3.
Remove the front door window glass mounting hole plug.
  
Be careful not to drop the glass and/or scratch the glass surface.
  
Use the door switch to align the mounting hole/bolt with the hole in the door.
If unable to operate the window motor, remove the motor and align the hole by hand.
4.
Carefully adjust the front door window glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

(4Door, 5Door)

(2Door)

5.
Install in the reverse order of removal.
  
Roll the glass up and down to see if it moves freely without binding.
Adjust glass position as needed.
Make sure the door lock and opens properly.
Replace any damaged clips.
Front Door Window Glass Component Location
(4Door, 5Door) 1. Front door window glass (2Door) 1. Front door window glass ...

Front Door Module  Component Location
(4Door, 5Door) 1. Front door module (2Door) 1. Front door module ...

See also:

Record your key number
The key code number is stamped on the key code tag attached to the key set. Should you lose your keys, this number will enable an authorized Kia dealer to duplicate the keys easily. Remove the k ...

Alternator Description
The charging system included a battery, an alternator with a built-in regulator, and the charging indicator light and wire. The Alternator has eight built-in diodes, each rectifying AC curre ...

Cooling Fan Inspection
Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...

Copyright © www.kifomanual.com 2014-2024