(4Door, 5Door, 2Door) |
1. |
Remove the front door module.
(Refer to Front Door - "Front Door Module")
|
2. |
Disconnect the front door outside handle connector (A).
|
3. |
Remove the hole plug (B).
|
4. |
After loosening the mounting bolt, then remove the front door
outside handle cover (A).
|
5. |
Remove the front door outside handle (A) by sliding it rearward.
|
6. |
Install in the reverse order of removal.
|
Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents
are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower
of driv ...
Cylinder Head Cover Components
1. Cylinder head cover
2. Cylinder head cover gasket
...
In-car Sensor (DATC only) Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...