Kia Forte: Adjustment
Glass Adjustment
•
|
Check the glass run channel for damage or deterioration,
and replace them if necessary.
|
|
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
2. |
Remove the rear door window glass mounting hole plug.
|
3. |
Carefully move the rear door window glass (A) until the glass
mounting bolts are visible, then loosen them.
|
4. |
Check that the glass moves smoothly.
|
Door Striker Adjustment
•
|
Make sure the door latches securely without slamming it.
If necessary adjust the striker (A): The striker nuts are fixed.
The striker can be fine adjusted up or down, and in or out.
|
|
1. |
Loosen the screws (B) just enough for the striker to move.
Tightening torque :
(B) : 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
|
|
2. |
Tap on the striker with a plastic hammer to adjust the striker.
The striker will not move much, but will give some adjustment.
|
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches properly,
tighten the screws and recheck.
|
Door Position Adjustment
•
|
After installing the door, check for a flush fit with
the adjacent body panels, then check for equal gaps between
the front, rear, and bottom, door edges and the body. Check
that the door and body edges are parallel. Before adjusting,
replace the mounting
|
|
1. |
Check that the door and body edges are parallel.
|
2. |
Place the vehicle on a firm, level surface when adjusting the
doors.
|
3. |
Adjust at the hinges (A):
A. |
Loosen the door mounting bolts slightly, and move the
door in or out until it aligns flush with the body.
|
B. |
Loosen the hinge mounting bolts slightly, and move the
door backward or forward, up or down as necessary to equalize
the gaps.
|
C. |
Place a shop towel on the jack to prevent damage to the
door when adjusting the door.
|
Tightening torque :
(B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)
(C) : 33.3 ~ 41.2 N.m (3.4 ~ 4.2 kgf.m, 24.6 ~ 30.4 lb-ft)
|
|
4. |
Grease the pivot portions of the hinges indicated by the arrows.
|
5. |
Check for water leaks.
|
(4Door, 5Door)
1. Rear door inside handle cap
2. Rear door pull handle cap
3. Rear door trim
4. Rear door rear seal
5. Rear door panel
6. Rear door module
7. ...
(4Door, 5Door)
1. Rear door trim
...
See also:
Replacement
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
For best battery service
Keep the battery securely mounted.
Keep the battery top clean and dry.
Keep the terminals and connections clean, tight, and coated with petroleum
jelly or terminal grease.
Rinse any spi ...
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...