(4Door) |
|
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
2. |
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
3. |
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
|
4. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
5. |
Slighty remove the rear door body side weatherstrip.
|
6. |
After loosening the mounting clips and screws, then remove the
rear partition trim (A).
|
7. |
Using a screwdriver or remover, remove the rear wheel house trim
(A).
|
8. |
Install in the reverse order of removal.
|
|
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
2. |
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
|
3. |
Remove the rear shelf side trim.
(Refer to Interior Trim - "Rear Shelf Side Trim")
|
4. |
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
|
5. |
Slighty remove the rear door body side weatherstrip.
|
6. |
After loosening the mounting screw, then remove the rear wheel
house trim (A).
|
7. |
Install in the reverse order of removal.
|
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). The green arrow indicators on the instrument
panel indicate which tur ...
Rear Hub - Carrier Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from ...
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...