Kia Forte: Rear Seat Cushion Cover Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the rear seat heater control unit connector (A).

3.	After removing the hog-ring clips (A) on the rear of seat cushion and remove the rear seat cushion cover (B). [Rear side] [Front side]

4.

Install in the reverse order of removal.

•	To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Rear Seat Cushion Cover Component Location

1. Rear seat cushion cover ...

Rear Back Armrest Component Location

1. Rear back armrest ...

See also:

Accelerator Pedal Installation
1. Install in the reverse order of removal. Accelerator pedal module installation nut: 12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...

Installation
Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Starter Cleaning
1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. ...

Categories

Copyright � www.kifomanual.com 2014-2026