Kia Forte: IMS Control Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Control Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the seat side cover (A).
|
| 3. |
Disconnect the power seat control switch connector (A).
|
| 4. |
Remove the power seat control switch (A) after loosening the mounting
screw.
|
IMS Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
IMS Control Switch Installation
1.
Connect the connector and install the power seat control switch.
2.
Install the seat cover.
...
See also:
Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by the signal from the control unit. Pressing the intake selection switch
will shift between recirculation and ...
Back up lamp, Rear fog lamp
1. Take the lamp assembly out.
2. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
3. Remove the bulb by ...
Copyright © www.kifomanual.com 2014-2025