1. |
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
|
2. |
Remove the cluster fascia panel.
(Refer to Body - "Cluster Fascia Panel")
|
3. |
After loosening the mounting screws, remove the drive airvent
duct assembly (A).
|
4. |
After loosening the mounting screws, disconnect the connector
(A), and then remove the center fascia cover (B).
|
5. |
Disconnect the clock switch connector (A).
|
6. |
After loosening the mounting screws, remove the center airvent
duct assembly [RH] (A).
|
7. |
Remove the in-car hose (A).
|
8. |
Disconnect the in-car sensor connector (B).
|
9. |
After loosening the mounting screws, remove the A/C & heater controller
(A).
|
10. |
Disconnect the A/C & heater controller connector (A).
|
11. |
Install in the reverse order of removal.
|
ETC (Electronic Throttle Control) System Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
Replace it with TPS 2
TPS 2 fault
Replace it with T ...
Power Seat Motor Inspection
Power Seat Motor
1.
Remove the seat and all motor connectors.
A : Slide motor
B : Height motor
C : Tilt motor
D : Recline motor
...
Components
1. Reverse hose
2. Master cylinder
3. Ignition lock switch
4. Clutch switch
5. Clutch arm assembly
6. Pedal pad
...