1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the overhead console lamp assembly (A) after loosening
2 screws.
|
3. |
Check for continuity between the terminals.
|
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mul ...
Front Pillar Trim Replacement
•
Put on gloves to protect your hands.
&n ...
Output Speed Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...