Kia Forte: Sunroof Motor Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Sun Roof / Sunroof Motor Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly")

3.	Disconnect the sunroof motor (A) connector.

Ground the terminals as below table, and check that the sunroof unit operates.

-	When inspecting the sunroof motor operation, sunroof motor and roller blind motor always should be connected.

Make these input tests at the connector. If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the sunroof motor must be faulty; replace it.

Terminal	Test condition	Test: Desired result
3	IG2 ON	Check for voltage to ground: There should be battery voltage.
1	Under all conditions	Check for continuity to ground: There should be continuity.
6	Under all conditions	Check for voltage to ground: There should be battery voltage.

Sunroof Switch Inspection

1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp assembly (A) after loosening 2 screws. ...

Resetting The Sunroof

Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows : 1. ...

Kia Forte: Sunroof Motor Inspection

Sunroof Switch Inspection

Resetting The Sunroof

See also:

Categories