Kia Forte: Resetting The Sunroof
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Sun Roof / Resetting The Sunroof
Whenever the vehicle battery is disconnected or discharged, or you use
the emergency handle to operate the sunroof, you have to reset your sunroof
system as follows :
| 1. |
Turn the ignition key to the ON position and then close the sunroof
completely.
|
| 2. |
Release the sunroof control lever.
|
| 3. |
Press and hold the CLOSE button for more than 10 seconds until
the sunroof closed and it has moved slightly.
|
| 4. |
Release the sunroof control lever.
|
| 5. |
Press and hold the CLOSE button once again within 3 seconds until
the sunroof do as follows;
|
| 6. |
Reset procedure of sunroof system is finished.
|
Protecting Motor From Overheating
In order to protect the sunroof motor from overheating from continuous
motor operation, the sunroof ECU controls the Run-time and Cool-time of the
motor as follows:
| 1. |
The sunroof ECU detects the Run- time of motor
|
| 2. |
Motor can be operated continuously for the 1st run-time (120 ±
10sec.).
|
| 3. |
The continuous operation of motor stops after the 1st Run-time
(120 ± 10sec.).
|
| 4. |
Then Motor is not operated for the 1st Cool-time (18 ± 2sec.).
|
| 5. |
Motor is operated for the 2nd Run-time (10 ± 2sec.) at the continued
motor operation after 1st Cool-time (18 ± 2sec.)
|
| 6. |
The continuous operation of motor stops operating after the 2nd
Run-time (10 ± 2sec.)
|
| 7. |
Motor is not operated for the 2nd Cool-time (18 ± 2sec.).
|
| 8. |
Motor repeats the 2nd run-time and 2nd cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 9 ± 2 sec., T4 : 18 ± 2 sec.
|
Sunroof Motor Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
...
Lighting System
...
See also:
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly.
...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Hood Assembly Replacement
•
Be careful not to damage the hood and body.
...
Copyright © www.kifomanual.com 2014-2025