Kia Optima Manuals

Kia Forte: Head Lamp Aiming Instructions - Lighting System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Head Lamp Aiming Instructions

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Head Lamp Aiming Instructions

The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions.
  
If there are any regulations pertinent to the aiming of head lamps in the area where the vehicle is to be used, adjust so as to meet those requirements.
Alternately turn the adjusting gear to adjust the head lamp aiming. If beam-setting equipment is not available, proceed as follows:
1.
Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools.
2.
The vehicle should be placed on a flat floor.
3.
Draw vertical lines (Vertical lines passing through respective head lamp centers) on the screen.
4.
With the head lamp and battery in normal condition, aim the head lamps so the brightest portion falls on the vertical lines.
A : Vertical(Low)
Front Fog Lamp Aiming
The front fog lamps should be aimed as the same manner of the head lamps aiming.
With the front fog lamps and battery normal condition, aim the front fog lamps by turning the adjusting screw (A) with a driver.

Head Lamp And Fog Lamp Aiming Point

1.
Head Lamp (Low beam)
A.
Turn the low beam on without driver aboard.
B.
The cut-off line should be projected in the cut-off line shown in the picture.
C.
If head lamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.

2.
Turn the front fog lamp on without the driver aboard.
The cut-off line should be projected in the allowable range (shaded region)
Head Lamps Installation
1. Install the head lamp bulbs. 2. Connect the connectors. 3. Install the head lamp bolts (3EA). ...

Room Lamp Inspection
Room Lamp 1. Check that the switch operates properly after disconnecting the room lamp connector (A). ...

See also:

Removal
1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

Replacement
1. Remove the cap (A) and remove the nuts, then remove the wiper arm (B). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 ...

Hood switch Inspection
1. Disconnect the hood switch connector (A). 2. Check for continuity between terminals ...

Categories

Copyright www.kifomanual.com 2014-2026