Kia Forte: Checking the engine oil level - Engine oil - Maintenance - Kia Forte TD 2014-2018 Owners ManualKia Forte: Checking the engine oil level

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Maintenance / Engine oil / Checking the engine oil level

1. Be sure the vehicle is on level ground.


1. Be sure the vehicle is on level ground.

2. Start the engine and allow it to reach normal operating temperature.

3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.

4. Pull the dipstick out, wipe it clean, and reinsert it fully.

WARNING - Radiator hose

Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.

5. Pull the dipstick out again and check the level. The level should be between F and L.

CAUTION - Replace engine oil

Do not overfill with engine oil. Engine damage may result.

If it is near or at L, add enough oil to bring the level to F. Do not overfill.


If it is near or at L, add enough oil to bring the level to F. Do not overfill.

Changing the engine oil and filter

Have engine oil and filter changed by an authorized Kia dealer according to the Maintenance Schedule at the beginning of this chapter.

WARNING - California proposition 65

Engine oil contains chemicals known to the State of California to cause cancer, birth defects and reproductive harm. Used engine oil may cause irritation or cancer of the skin if left in contact with the skin for prolonged periods of time. Always protect your skin by washing your hands thoroughly with soap and warm water as soon as possible after handling used oil.

Engine oil
...

Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant level at least once a ...

See also:

Head Lamps Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Fuel Tank Pressure Sensor (FTPS) Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Copyright © www.kifomanual.com 2014-2025