Kia Forte: Hazard Lamp Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
|
| 3. |
Remove the hazard switch (A) after loosening the screws.
|
License Lamp Installation
1.
Connect the connector.
2.
Install the license lamp.
...
Hazard Lamp Switch Installation
1.
Install the hazard switch.
2.
Install the center fascia panel.
...
See also:
On-board Refueling Vapor Recovery (ORVR) valve Installation
1.
Installation is the reverse of removal.
...
SRSCM Connector Terminal
Pin
Function (Connector
A)
Pin
Function (Connector
B)
1
Ignition
1
Passenger side impact sensor (+)
2
-
...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Copyright © www.kifomanual.com 2014-2025