Kia Forte: Parking Assist System
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System
- Specification
- Component Location
- System Overview
- Parking Assist Sensor Component
- Parking Assist Sensor Removal
- Parking Assist Sensor Installation
- Parking Assist System Switch Removal
- Parking Assist System Switch Installation
Antenna Coil Installation
1.
Install the antenna coil.
2.
Connect the antenna coil connector.
3.
Install the crash pad lower panel.
...
Specification
Item
Specification
Ultrasonic sensor
Voltage rating
DC 12 V
Detecting range
30 cm ~ 120 cm
Operation voltage
DC 9 ~ 16 ...
See also:
Rear Door Outside Handle Replacement
(4Door, 5Door)
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside
handle cov ...
Replacement
Front brake pads
1.
Loosen the guide rod bolt (B) and pivot the caliper (A) up out
of the way.
Tightening torque:
21.6 ~ 31.4 N.m ...
Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Copyright © www.kifomanual.com 2014-2025