Kia Forte: Parking Assist System Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist System Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly")
|
| 3. |
Disconnect the switch connectors (A).
|
| 4. |
Remove the switchs (A) from the console upper cover.
|
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
Parking Assist System Switch Installation
1.
Install the switchs and connect the switch connectors.
2.
Insatll the floor console assembly.
3.
Connect the ...
See also:
Overhead Console Lamp Inspection
1.
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
...
Seat Heater (Air Ventilation) Circuit Diagram
...
Front Wheel Speed Sensor Removal
1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Copyright © www.kifomanual.com 2014-2025