Kia Forte: Thermostat Inspection - Cooling System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Thermostat Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Thermostat Inspection

1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.
If the valve opening temperature is not as specified, replace the thermostat.

Valve opening temperature:
88 ± 1.5°C (190.4 ± 34.7°F)
Full opening temperature: 100°C (212°F)

3.
Check the valve lift.
If the valve lift is not as specified, replace the thermostat.

Valve lift : 8 mm (0.3 in.) or more at 100°C (212°F)

Thermostat Removal and Installation
   Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting ...

See also:

Canister Close Valve (CCV) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the proced ...

Fuel Tank Pressure Sensor (FTPS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...

Copyright � www.kifomanual.com 2014-2026