Kia Forte: Intake Manifold Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Intake And Exhaust System / Intake Manifold Removal and Installation

1.	Remove the engine cover.

2.	Disconnect the battery negative terminal.

Disconnect the wiring connectors and harness clamps, and then remove the wiring and protectors from the intake manifold.

(1)	The intake oil control valve (OCV) connector (A)

(2)	The alternator connector (A)

(3)	The variable Intake solenoid (VIS) connector (A)

(4)	The manifold absolute pressure sensor (MAPS) & intake air temperature sensor (IATS) connector (A)

(5)	The electronic throttle control (ETC) connector (A)

(6)	The variable charge motion actuator (VCMA) connector (A)

4.	Disconnect the positive crankcase ventilation (PCV) hose (A).

5.	Disconnect the vacuum hose (A) and purge control solenoid valve (PCSV) hose (B).

6.	Unfasten the electric throttle body control (ETC) module bolts. (Refer to Engine Control/Fuel System - "ETC (Electric throttle body control) System")

Remove the intake manifold stay (A).

Tightening torque :

18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

Remove the intake manifold (A) with the gasket (B).

Tightening torque :

18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

When installing the intake manifold, tighten the bolts and nuts with pre-torque first, and then tighten the bolts and nuts with specified torque in the sequence shown.

9.	Install in the reverse order of removal.

Intake Manifold Components

1. Intake manifold assembly 2. Intake manifold gasket 3. Electronic throttle body 4. Intake manifold stay ...

Variable Intake Solenoid(VIS) Actuator Removal and Installation

1. Disconnect the vacuum hose (A). 2. Remove the variable Intake solenoid (VIS) actuator (B) Tightening torque : ...

Kia Forte: Intake Manifold Removal and Installation

Intake Manifold Components

Variable Intake Solenoid(VIS) Actuator Removal and Installation

See also:

Categories