Kia Forte: Description - Ignition System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Description

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Ignition System / Description

Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.
Ignition System
...

On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

See also:

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Circuit Diagram
...

Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable t ...

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

Copyright © www.kifomanual.com 2014-2024