Kia Forte: ETC (Electronic Throttle Control) System Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Inspection

Throttle Position Sensor (TPS)

1.	Connect the GDS on the Data Link Connector (DLC).

2.

Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

Throttle Angle	Output Voltage (V)
Throttle Angle	TPS 1	TPS 2
C.T	0.5	4.5
W.O.T	4.41	0.59

ETC Motor

1.	Turn the ignition switch OFF.

2.	Disconnect the ETC module connector.

3.	Measure resistance between the ETC module terminals 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to â€œSpecificationâ€

ETC (Electronic Throttle Control) System Circuit Diagram

(M/T) (A/T) ...

ETC (Electronic Throttle Control) System Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to â€ ...

See also:

Setup
Display Settings Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up] Changes / selection mode During On stat ...

Positive Crankcase Ventilation (PCV) Valve Operation Principle
...

Thermostat Components
1. Water inlet fitting 2. Thermostat 3. Bypass hose 4. Heater pipe & hose assembly ...

Categories

Copyright ï¿½ www.kifomanual.com 2014-2026