Kia Forte: ETC (Electronic Throttle Control) System Installation - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: ETC (Electronic Throttle Control) System Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Installation

  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Install in the reverse order of removal.

Electronic throttle body Installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

ETC (Electronic Throttle Control) System Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to “I ...

Manifold Absolute Pressure Sensor (MAPS) Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...

See also:

Audio Remote Control Inspection
1. Check for resistance between terminals in each switch position. [Audio (LH)] Switch Connector terminal Resista ...

Seat Heater Inspection
Front Seat 1. Check for continuity and measure the resistance between terminals. No. Description No. Descripti ...

Smart key
With a smart key, you can lock or unlock a door and even start the engine without inserting the key. The functions of the buttons on a smart key are similar to the remote keyless entry. (Refer ...

Copyright © www.kifomanual.com 2014-2025