Kia Forte: Accelerator Position Sensor (APS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Inspection
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Turn the ignition switch ON.
|
| 3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Accelerator Position Sensor (APS) Circuit Diagram
(M/T)
(A/T)
...
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
See also:
Radiator Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
2.
...
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A) , then disconnect the
connector.
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026