Kia Forte: Accelerator Position Sensor (APS) Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Installation
| 1. |
Install in the reverse order of removal.
|
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Fuel Tank Pressure Sensor (FTPS) Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge control solen ...
See also:
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Rheostat Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad side switch assembly (A).
3.
...
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
Copyright © www.kifomanual.com 2014-2025