Kia Forte: Injector Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Injector Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.

3.	Disconnect the injector connector (A).

4.	Disconnect the fuel feed tube quick-connector (B).

5.	Remove the installation bolt (C), and then remove the delivery pipe & injector assembly from the engine.

6.	Remove the fixing clip (A), and then separate the injector from the delivery pipe.

Injector Inspection

1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Injector Installation

• Install the component with the specified torques. • ...

Kia Forte: Injector Removal

Injector Inspection

Injector Installation

See also:

Categories