Kia Forte: Purge Control Solenoid Valve (PCSV) Inspection - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Purge Control Solenoid Valve (PCSV) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Purge Control Solenoid Valve (PCSV) Circuit Diagram
(M/T) (A/T) ...

Purge Control Solenoid Valve (PCSV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

See also:

Alternator Disassembly
1. Remove the rear cover (A) after removing nuts (B). 2. Remove the mounting bolts (A) and the regulator assembly (B). ...

SS-B Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(Ω ...

Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty. The spray and wip ...

Copyright � www.kifomanual.com 2014-2026