Kia Forte: CVVT Oil Control Valve (OCV) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the CVVT oil control valve connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
CVVT Oil Control Valve (OCV) Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
CVVT Oil Control Valve (OCV) Installation
•
Install the component with the specified torques.
•
...
See also:
Transaxle Oil Temperature Sensor Circuit Diagram
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
Rear Torsion Beam Axle Components
1. Rear torsion beam axle
...
Copyright © www.kifomanual.com 2014-2025