Kia Optima Manuals

Kia Forte: Variable Charge Motion Actuator (VCMA) Installation - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Variable Charge Motion Actuator (VCMA) Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  
The VCM actuator has to be installed at the fully closing positon of the VCM valve.
If it doesn't, the VCM coupling of the VCM shaft can't be put in the the VCM actuator.
1.
Install in the reverse order of removal.
Variable charge motion actuator installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Variable Charge Motion Actuator (VCMA) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the VCMA connector (A). ...

ISG (Idle Stop & Go) System
...

See also:

Special Service Tools
Tool Name / Number Illustration Description Band installer 09495-3K000 Installation of ear type boot band Puller 09495-33000 ...

Accelerator Position Sensor (APS) Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...

Manifold Absolute Pressure Sensor (MAPS) Specification
Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 101.3 (1.03, 14.7) 4.0 ...

Categories

Copyright www.kifomanual.com 2014-2025