Kia Optima Manuals

Kia Forte: Alternator Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Removal

1.
Disconnect the battery negative (-) cable.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Timing Chain")
3.
Disconnect the alternator connector (A) and the cable from the alternator "B" terminal (B).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

4.
Remove the alternator (A) after removing the bolts.
Tightening torque :
[12 mm bolt] 21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)
[14 mm bolt] 29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

Alternator On-vehicle Inpection
   • Check that the battery cables are connected to the correct terminals. ...

Alternator Intallation
1. Install in the reverse order of removal.    Adjust the alternator belt te ...

See also:

Parking Assist System Switch Installation
1. Install the switchs and connect the switch connectors. 2. Insatll the floor console assembly. 3. Connect the ...

ISG OFF Switch Inspection
1. Remove the crash pad side switch assembly (A) from the switch panel on the crach pad of the driver's side. 2. Remove the ISG ...

Back up lamp, Rear fog lamp
1. Take the lamp assembly out. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb by ...

Categories

Copyright www.kifomanual.com 2014-2026