Kia Forte: Oil Pump Unit (OPU) Installation

Oil Pump Unit (OPU) Removal

1. Remove the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - “Crash Pad�) ...

Oil Pump Unit (OPU) Inspection

OPU Problem Inspection Procedure 1. TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector ...

See also:

Rear Torsion Beam Axle Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the rear axle carrier for cracks. ...

Rearview camera
The rear view camera will activate with the ignition switch on and the shift lever in the R (Reverse) position. Note- during initial start up, system may not display instantly due to the audio ...

Evaporator Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, measur ...