1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
3. |
Disconnect the injector connector (A).
|
4. |
Disconnect the fuel feed tube quick-connector (B).
|
5. |
Remove the installation bolt (C), and then remove the delivery
pipe & injector assembly from the engine.
|
Heater & A/C Control Unit (DATC) Component
Connector Pin Function
Connector
No.
Description
Connector
No.
Description
A
1
Illumination (+) (Tail)
A
...
Cooling Fan Specifications
Item
Specification
Fan type
PULLER
Fan speed control
Resistor (HI-LOW-OFF)
Air flow rate [㎥/h (yd³/h)]
1,700 (2,22 ...
Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...