Kia Optima Manuals

Kia Forte: Installation - Clutch Cover And Disc - Clutch System - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Cover And Disc / Installation

  
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline part and transaxle input shaft spline part as required.
  
Possible problems when not following
•
When not applying: Excessive wear of splines and bad clutch operation can occur.
•
When excessively applying: Grease can be scattered by centrifugal force which can contaminate the clutch disc. This can cause a loss of friction force causing a slip.
2.
Install the clutch disc and the cover by using the SST (09411-1P000).
  
•
When installing the cover, remove the foreign of material of flywheel and pressure plate completely.
•
Make sure about the direction of the clutch disk when installing.

Possible problems when the disc is installed in the opposite direction.
•
Transaxle shift error or a strange sound can occur due to clutch separation.

3.
Tighten the clutch cover bolts.
Tightening torque
Gasoline 1.6 T-GDI : 24.5 ~ 35.3 N.m(2.5 ~ 3.6 kgf.m, 18.1 ~ 26.0 lb-ft)
Gasoline 1.8 / 2.0 : 11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
  
•
Loosely tighten every clutch cover bolts, then torque to specifications in a diagonal direction. This can prevent twisting, vibration of the cover, and the lifting of the pressure plate.
•
Install the all the components with the specified torques. If not, the clutch torque transaxle may have concerns or the mounting bolt can loosen.

4.
Install the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
Inspection
1. Inspect diaphragm spring wear which is in contact with a clutch release bearing. 2. Check the clutch cover and disc surface for wear or ...

Clutch Switch
...

See also:

Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...

Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characterist ...

Inspection
1. Check the brake warning lamp in the IGN ON position.    Brake warnin ...

Categories

Copyright www.kifomanual.com 2014-2025