Kia Forte: Vehicle break-in process - Introduction - Kia Forte TD 2014-2018 Owners ManualKia Forte: Vehicle break-in process

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / Introduction / Vehicle break-in process

No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle.

Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performan ...

Vehicle data collection and event data recorders
This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road o ...

See also:

Dynamic Damper Installation
1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the heater & A/C control unit. (Refer to Heating,Ventilation, Air Conditi ...

Emergency Fastening Device (EFD)
Front emergency fastening device operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and ...

Copyright www.kifomanual.com 2014-2026