Kia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) / Removal

Pressure Side Impact Sensor

•	Removal of the airbag must be performed according to the precautions/procedures described previously.

•	Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front door trim. (Refer to Body - "Front door trim")

3.	Disconnect the pressure side impact sensor connector (A).

4.	Loosen the pressure side impact sensor mounting screws (B) and then remove the pressure side impact sensor.

Side Impact Sensor

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the door scuff trim. (Refer to Body - "Door scuff trim")

3.	Remove the center pillar lower trim. (Refer to Body - "Center pillar trim")

4.	Disconnect the side impact sensor connector (A).

5.	Loosen the side impact sensor mounting bolt and then remove the side impact sensor (B).

Components

...

Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

See also:

Seat belt restraint system
Seat belts are designed to bear upon the bony structure of the body, and should be worn low across the pelvis, chest and shoulders as applicable. Wearing the lap section of the belt across the abdom ...

Rear Bumper Cover Component Location
(4Door) 1. Rear Bumper Cover (2Door) 1. Rear bumper cover (5Door) 1. Rear bumper cover ...

Power Mosfet Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. ...

Categories

Copyright � www.kifomanual.com 2014-2026