Kia Forte: Installation
|
Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
| •
|
Do not open the lid of the side airbag cover.
|
| •
|
Make sure that the airbag assembly cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
|
3. |
Install the new seat back assembly.
|
|
4. |
Install the front seat assembly.
(Refer to Body - "Front seat assembly")
|
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfering with other parts.
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain airbag by us ...
See also:
Telemetics Unit (TMU) Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
...
Interior light
Do not use the interior lights for extended periods when the engine is not running.
It may cause battery discharge.
WARNING - Interior light
Do not use the interior lights when driving in the dark ...
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
...