1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the seat belt pretensioner with bolts (B).
|
4. |
Connect the seat belt pretensioner connector (A).
|
5. |
Install the upper anchor bolt.
|
6. |
Install the center pillar trim.
(Refer to Body - "Center pillar trim")
|
7. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
|
8. |
Insert the seat belt to the Emergency fastening device.
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the seat belt pretensioner, confirm proper system
operation:
|
Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation
of the transaxle's turbine shaft and output shaft, and delivers the readings
to the Transaxle Control Module(TCM ...
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Front Wiper Motor Removal
1.
Loosen the windshield wiper arm nut (B) after removing a wiper
cap (A).
2.
Remove the windshield wiper arm and blade.
...