Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the vacuum pump connector (A).
|
| 3. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 4. |
Disconnect the vacuum hose clip (A) and wiring harness clip (B)
from the vacuum pump bracket.
|
| 5. |
Remove the under covers (A).
|
| 6. |
Remove the intercooler inlet hose (A).
|
| 7. |
Disconnect the vacuum hose (A).
|
| 8. |
Loosen the vacuum pump bracket bolts (A) and then remove vacuum
pump and bracket.
|
| 9. |
Remove the bolts and then remove the vacuum pump (A) and lead
wire assembly (B) from the bracket (C).
|
Vacuum Pump
Components
1. Vacuum pump
2. Bracket
3. Lead wire assembly
...
Inspection
1.
Check the brake warning lamp in the IGN ON position.
Brake warnin ...
See also:
Room Lamp Installation
Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Hazard Lamp Switch Installation
1.
Install the hazard switch.
2.
Install the center fascia panel.
...
Copyright © www.kifomanual.com 2014-2025