Kia Optima Manuals

Kia Forte: Front Door Module  Replacement - Front Door - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Front Door Module  Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module  Replacement

1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Disconnect the front door main connector (A).
3.
Disconnect the outside rear view mirror connector (A).
(4Door, 5Door)

(2Door)
4.
Loosen the front door latch (B) mounting screws.
5.
After loosening the mounting bolts, then remove the front door module (A).
Tightening torque :
Bolt : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Screw : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
(4Door, 5Door)

(2Door)
6.
Disconnect the front door outside handle connector (A) and remove the front door outside handle rod (B).

7.
Remove the front door main connector pad (A) and mounting clip (B).
8.
Disconnect the front door latch connectors (A).
9.
Disconnect the connectors and front door module wiring harness (A).
10.
Remove the front door latch assembly.
(Refer to Front Door - "Front Door Latch")
11.
Reomove the front speaker .
(Refer to Body Electrical System - "Speakers")
12.
Remove the front power window motor.
(Refer to Body Electrical System - "Power Window Motor")
13.
Install in the reverse order of removal.
  
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
Front Door Module  Component Location
(4Door, 5Door) 1. Front door module (2Door) 1. Front door module ...

Front Door Outside Handle Component Location
(4Door, 5Door, 2Door) 1. Front door outside handle ...

See also:

Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Severe ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

Categories

Copyright www.kifomanual.com 2014-2026