Kia Forte: Front Seat Cushion Track Replacement
| •
|
When replacing the WCS, be sure to check the parts unit.
|
| -
|
Parts unit of WCS : seat track assembly
|
|
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover")
|
|
2. |
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
|
|
3. |
Loosen the front seat cushion track front mounting bolt (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
|
|
4. |
Pull up the front seat cushion track.
|
|
5. |
Disconnect the rear height motor connector (A).
|
|
6. |
Loosen the front seat cushion track rear mounting bolt (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
|
|
7. |
After loosening the mounting bolts and nuts, then remove the front
seat cushion track (A).
Tightening torque :
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)
|
[LH]
[RH]
|
|
8. |
Install in the reverse order of removal.
|
• |
Make sure the connector is plugged in properly.
|
|
• |
Replace any damaged clips.
|
|
|
1. Front seat cushion track
...
See also:
Fuel Filter Installation
1.
Install in the reverse order of removal.
...
Front Body
Front Body A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front Body B
* These dimensions indicated in th ...
Brake Switch Installation
1.
Install in reverse of removal.
...
Front Seat Cushion Track Component Location
Rear Seat