Kia Forte: Fuel Pressure Regulator Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Fuel Pressure Regulator Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pressure Regulator Removal

1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).

3.
Remove the head assembly (A) after releasing the cushion fixing clip (B).

4.
Disconnect the fuel tube quick-connectors (C).

5.
Remove the fuel sender (A) in the direction of an arrow.

6.
Disconnect the fuel tube connector (A).

7.
Remove the cut valve (A) after releasing hooks (B).

8.
Remove the reservior-cup (B) after releasing the fixing hooks (A).

9.
Release the fixing hooks, and then remove the pre-filter (A) and the fuel pressure regulator (B).

  
Be careful of O-ring.

1. Head Assembly
2. Electric Pump Motor
3. Fuel Filter
4. Fuel Sender
5. Fuel Pressure Regulator
6. Pre-filter
7. Reservoir cup
Fuel Sender Installation
1. Install in the reverse order of removal. ...

Fuel Pressure Regulator Installation
1. Install in the reverse order of removal. ...

See also:

Hazard Lamp Switch Installation
1. Install the hazard switch. 2. Install the center fascia panel. ...

Specification
Item Description Power source 3V Operating temperature -20°C ~ +60°C (-4°F ~ 140°F) RF Modulation FSK LF Modulati ...

Auto Head Lamp Leveling Unit Operation
Operating Procedure 1. Suspension angle change resulted from vehicle's load change. 2. Sensor angle change. 3. ...

Copyright © www.kifomanual.com 2014-2023