Kia Forte: Fuel Tank Removal
| 1. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
| 2. |
Remove the rear seat cushion (Refer to “Seat” in BD group).
|
| 3. |
Remove the fuel pump service cover (A).
|
| 4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure
sensor connector (B).
|
| 5. |
Disconnect the fuel feed tube quick connector (C).
|
| 6. |
Remove the rear - LH wheel & tire.
|
| 7. |
Lift the vehicle and support the fuel tank with a jack.
|
| 8. |
Disconnect the fuel filler hose (A).
|
| 9. |
Disconnect the vapor tube quick-connector (A).
|
| 10. |
Remove the under cover (A) after loosening the mounting nuts.
|
| 11. |
Remove the fuel tank from the vehicle after removing the fuel
tank band.
|
| 12. |
Remove the fuel tank from the vehicle after removing the fuel
tank band (A).
|
Release Residual Pressure in Fuel Line
There may be some residual pressure even after “Release Residual
Pressure in Fuel Line” work, so cover the hose connecti ...
Fuel Tank Installation
1.
Install in the reverse order of removal.
Fuel tank band installation
nut:
39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
...
See also:
ETC (Electronic Throttle Control) System Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to “I ...
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
Intake Manifold Components
1. Intake manifold assembly
2. Intake manifold gasket
3. Electronic throttle body
4. Intake manifold stay
...
Copyright © www.kifomanual.com 2014-2025